Comments

  • DaveP 10:00 am on February 26, 2009 | #

    Isn’t adding a bunch of cutting and welding just over complicating the procedure?? 😉

  • shedfire 10:02 am on February 26, 2009 | #

    Easier that swaging the tube down to 22.2mm. This way we can have the wall thicknesses we want, where we want them.

  • DaveP 10:08 am on February 26, 2009 | #

    Limited size production run?

  • shedfire 10:10 am on February 26, 2009 | #

    It was more a kind of proof of concept of manufacture to be honest. We will have a few options I’d imagine. £200 RRP.

  • Flamejob 12:05 pm on February 26, 2009 | #

    What a great idea! Eeek at the cost; is a production version feasible?

  • DaveP 8:17 pm on February 26, 2009 | #

    Think I used a pair of your pre-prod Ti bars in the past. These look ermmm.. More purposeful.

Leave a Comment

Flickr Stream

NANGNAM style - we've been at the Taipei Bike Show for two days, held in the Nangnam Exhibition centre...Singlepivot vs Horst Link Codeine with same rocker configuration #knewIwasntgoingmadSinglepivot vs Horst Link Codeine with same rocker configuration #knewIwasntgoingmadRovaneimi Start vid by @bikiechicoRovaneimi 150Rovaneimi 150Rovaneimi 150Rovaneimi 150Rovaneimi 150Tea time for @greatrock. 26in reindeer and blue cheese pizza.Pre race pub prep #finlandiaPre race pub prep #finlandiaWe went to see Santa. But weren't allowed to take picsWe went to see Santa. But weren't allowed to take picsWe went to see Santa. But weren't allowed to take picsWe went to see Santa. But weren't allowed to take picsCarbo loadingCodeine. Proto on-one 29er FSCodeineGetting there slowly #finlandia